If your Invisible Fence control panel is beeping with a lengthy pause between each beep, it’s possible your backup battery unit needs to be replaced. Your fence will still work, but if your power goes out, the system will no longer be operational until power is restored.
What does blinking blue light on invisible fence mean?
Status Indicator Light
The signal field wire is intact, continuous, and the transmitter’s Status Indicator Light is blinking blue. d. The Computer Collar® Unit is correctly fitted and worn by your pet. The Computer Collar® Unit must be adjusted so that both of the correction posts touch your pet’s skin.
Why does my petsafe transmitter keeps beeping?
If the transmitter still beeps / no loop light on Short Loop Test, please contact our Customer Care Center to discuss having unit replaced. If the transmitter is functioning properly on the Short Loop Test, you have a break in your boundary wire.
Why is my extreme dog fence beeping?
There is a nick or break in your boundary wire. Your transmitter itself: Do a short loop test to check and make sure that your transmitter is operational. If the transmitter continues to beep, this could mean the transmitter is no longer working.
Why does my petsafe collar not work?
Take battery out of the collar for several minutes and replace it with new battery. Make sure battery is installed properly. Make sure the tab within the battery housing unit is making good contact. If receiver collar still does not activate – remove a wire from the transmitter, try to change the levels.
How do I reset my petsafe transmitter?
How do I re-synchronize my wireless system?
- Remove the receiver collar from your pet.
- Remove the battery from the receiver collar.
- At the transmitter, move the boundary switch from the low to the high position.
- Slowly adjust the boundary control dial up to #8, down to #1 and then back to the #4 position.
How can you tell if your invisible fence is working?
A light on the battery tester and audible tone on the receiver confirms that the collar is operating properly. If you get the audible warning but not a light, replace the battery.
What’s the best way to troubleshoot an invisible fence?
It should either flash red lights or set off an alarm. Remove the ends of the fence wire from the transmitter jacks and replace them with the ends of a spare piece of wire. The wire doesn’t have to be any special type, but will work best if it’s near the gauge of the wiring used in the invisible fence.
How do you turn off invisible fence collar?
As a safety feature if the collar is on your pet while you try and do the items below it will just turn off. Press and hold the mode/on the button. The green light will come on after about 1 second. The green indicator light will flash just once then go off for 1 second.
How does an invisible fence work for dogs?
An invisible fence uses RF, or radio frequency, waves to detect when the transmitter on your dog’s collar passes an invisible line in your yard. This information goes to an RF transmitter box located in your home or garage. The transmitter box starts to beep to notify you that your dog left the yard.
Is it safe to use a power cap on Invisible Fence?
Using a fresh, genuine Invisible Fence Power Cap battery is the safest, easiest and most reliable way to guarantee your pet’s safety 100% of the time. You can purchase Power Cap batteries online or from your local dealer. You might have one or more wire breaks.
